black and decker power connect drill

WARNING: Read all safety warnings, instructions, and cautionary markings for the battery pack, charger and product. NOTE: For best results, make sure your battery pack is fully charged. When the chuck is nearly tightened you will hear a clicking sound. WARNING: To reduce the risk of serious personal injury, turn unit off and remove the battery pack before making any adjustments or removing/ installing attachments or accessories. Check to make sure that the gear box is not in-between gears and is completely transitioned to the desired gear. If battery liquid gets into the eye, rinse water over the open eye for 15 minutes or until irritation ceases. Slow spinning or no spin is a sign that the gears within the gear box may not have properly seated. Charger will not charge a faulty battery pack, which may be indicated by the light staying OFF or the red light rapidly blinking. A good drill is a fundamental tool everyone should own. Take charger and battery pack to an authorized service center if light stays OFF or red light rapidly blinks. If it still does not spin, then the transmission may be faulty and a replacement will be required. The motor becoming faulty can be caused by overloading the motor or the brushes within the motor wearing out. Damage or personal injury could result. Black & Decker (U.S.) Inc. warranties this product to be free from defects in material or workmanship for a period of two (2) years following the date of purchase, provided that the product is used in a home environment. Veja detalhes no carrinho. End of page 1 of 2 scroll down for more Black & Decker 18v Power Connect Battery system, Bosch Carbide Performance Power Tool Accesories, Dewalt Air Lock & Dust Extraction Systems. Do not attempt to use it on any other voltage. Make sure that the cord is located so that it will not be stepped on, tripped over or otherwise subjected to damage or stress. Some drills, 20V MAX* Lithium-Ion Drill/Driver, feature a built-in LED to illuminate your work surface. This is a normal condition, and does not indicate a problem. Nominal voltage is 18 volts. Refer to Installing a Bit or Accessory into a Keyless Chuck. Green charging light will continuously blink while charging. If in doubt, use the next heavier gauge. Do not allow water or any liquid to enter charger. Do not store or use the tool and battery pack in locations where the temperature may reach or exceed 104 F (40 C) (such as outside sheds or metal buildings in summer). corded If battery contents come into contact with the skin, immediately wash area with mild soap and water. 11-POSITION CLUTCH Prevents stripping and overdriving screws for added control. WARNING: ALWAYS use safety glasses. An extension cord must have adequate wire size (AWG or American Wire Gauge) for safety. Li-Ion tools are designed with an Electronic Protection System that will protect the battery pack against overloading, overheating or deep discharge. Accessibility. The motor is what the drill makes spin. An accidental startup can cause injury. Proof of purchase may be required. Austria Everyday eyeglasses are NOT safety glasses. This product is not intended for commercial use, and accordingly, such commercial use of this product will void this warranty. Use of improper extension cord could result in risk of fire, electric shock or electrocution. Do not disassemble the charger; take it to an authorized service center when service or repair is required. Loose clothes, jewelry or long hair can be caught in moving parts. A forward/reverse control button 2 determines the direction of the tool and also serves as a lock off button. Here is a guide to change the motor Motor Replacement, 2022 iFixit Licensed under Creative Commons Privacy If the trigger still cannot be pulled then a mechanical failure within the trigger may have occurred and a replacement switch will be required. WARNING: Read all safety warnings, instructions, and cautionary markings for the battery pack,charger and product. Pull the trigger switch applying pressure in a straight line with the bit until it reaches the desired depth. India When ordering replacement battery packs, be sure to include the catalog number and voltage. Then place the drill bit within the teeth and turn the outer ring clockwise until the teeth have securely been tightened around the bit. Grasp the black sleeve of the chuck with one hand and use the other hand to secure the tool. Your tool has a clutch with adjustable torque for driving and removing a wide array of fastener shapes and sizes. This drill driver is for consumer drilling and screwdriving applications.DO NOT use under wet conditions or in the presence of flammable liquids or gases.DO NOT let children come into contact with the tool.Supervision is required when inexperienced operators use this tool. Black & Decker 18v Lithium tools are also compatible with batteries from the more powerful 54v DualVolt range (though note that 18v batteries and battery chargers cannot be used with DualVolt products).With over 100 years of manufacturing experience, Black & Decker are one of the most established and widely known power tool manufacturers in the world today. Do not operate this tool for long periods of time. WARNING: Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury. The charger and battery pack may become warm to the touch while charging. These chargers are not intended for any uses other than charging BLACK+DECKER rechargeable battery packs. Do not operate the charger if it has received a sharp blow, been dropped or otherwise damaged in any way. Romania drill corded decker matrix driver ac amp expanded open summary Spain When drilling, always apply pressure in a straight line with the bit, but do not push hard enough to stall the motor or deflect the bit. WARNING: To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment (including brush inspection and replacement, when applicable) should be performed by a BLACK+DECKER factory service center or a BLACK+DECKER authorized service center. QUICK START GUIDE J312B THIS QUICK START GUIDE IS NOT A SUBSTITUTE FOR THE INSTRUCTION MANUAL. Vibration caused by the operating action of this tool may cause permanent injury to fingers, hands, and arms. Air vents often cover moving parts and should be avoided. Plug the charger into an appropriate outlet. Finland If the battery is working, the problem could be a bad motor. Hammer bits and tools get hot during operation. When transporting individual battery packs, make sure that the battery terminals are protected and well insulated from materials that could contact them and cause a short circuit.NOTE: Li-ion battery packs should not be put in checked baggage on airplanes and must be properly protected from short circuits if they are in carryon baggage. To facilitate the cooling of the battery pack after use, avoid placing the charger or battery pack in a warm environment such as in a metal shed or an uninsulated trailer. Chucks come in dual-sleeve and single-sleeve configurations, with single-sleeve offering easy one-handed operation. RBRC is a registered trademark of Call 2 Recycle, Inc. NOTE: The center position of the control button locks the tool in the off position. Insert and fully seat battery pack. BLACK+DECKER 20V MAX* POWERCONNECT Cordless Drill/Driver + 44 pc. Allowing dust to get into your mouth, eyes, or lay on the skin may promote absorption of harmful chemicals. Motor Replacement. matrix BLACK+DECKER owned and authorized service centers are listed online at www.blackanddecker.com. Turkey CORDLESS DRILL Compact, lightweight design for versatile use. If the drill bit is still not coming out hold the chuck and run the drill in reverse. Make sure the battery is connected and push the battery until it is secured to the drill. Returns should be made within the time period of the retailers policy for exchanges. Houve um problema; a solicitao no pde ser atendida no momento, Um nico ponto de compras para todos os produtos de suas marcas prediletas. volt Do not mix or stir flammable liquids labeled accordingly. If you need more precise speed control for diverse drilling or driving projects, a multi-speed drill like the BLACK+DECKER 20V MAX* Lithium-Ion 2-Speed Drill/Driver is worth a look. Pull the trigger switch applying pressure in a straight line with the bit until the fastener is seated at the desired depth in the workpiece. wecxas bdcdmt1206kitc D), Installing and Removing the Battery Pack (Fig. Store the fully charged battery pack out of the charger. When changing the position of the control button, be sure the trigger is released. 20v This does not apply to the vehicular charger. SET Includes a wide variety of bits and tools for drilling and driving tasks. Do not operate the charger with a damaged cord or plughave them replaced immediately. An awesome team of students from our education program made this wiki. Wear gloves when touching them. The Black & Decker 18v Power Connect battery platform constitutes a popular range of power tools for tackling DIY tasks around the home and garden. Insert the accessory about 3/4 (19 mm) into the chuck 4 and tighten securely by grasping and rotating the chuck sleeve clockwise with one hand while holding the tool with the other. Ocorreu um problema. The following table shows the correct size to use depending on total length of all extension cords plugged together, and nameplate ampere rating. The numbers 115 on the mode selection collar 3 are used to set a torque range for screwdriving. The hot/cold pack delay will be indicated by the red light continuously flashing a short ON followed by a longer ON (see charger for blink pattern). This limited warranty does not cover failures due to abuse, accidental damage or when repairs have been made or attempted by anyone other than BLACK+DECKER and its Authorized Service Centers. It the battery is good, it could be a bad in motor. When the trigger is pulled, the drill will not spin or make a noise. Follow this guide to find out if your switch has gone bad. Drill/Drivers do both jobs, which is convenient for projects like hanging a mirror, where you might drill a pilot hole then drive in a screw. Use the appropriate dust extractor vacuum to remove the vast majority of static and airborne dust. As a result, they are able to offer tried & tested products at competitive prices, along with a countrywide network of service & repair agents and a 2 year warranty on all power tools in the range. See Privacy Policy or Contact Us at support.blackanddecker@sbdinc.com or 701 E. Joppa Road, Towson, Maryland 21286, for more information. DO NOT allow water or any liquid to enter battery pack. corded decker Package Dimensions: 15.2 x 12.3 x 4.7 inches, Sign up for the latest news, offers and styles. Use gloves to provide extra cushion, take frequent rest periods, and limit daily time of use. This will reduce the risk of damage to the electric plug and cord. Use this guide to see how to remove and replace a motor within the drill. Czech Republic WARNING: When the mode selection collar is in the drill position, the drill will not clutch. Battery liquid may be flammable if exposed to spark or flame. Dirt and grease may be removed from the exterior of the charger using a cloth or soft non-metallic brush. ALWAYS WEAR CERTIFIED SAFETY EQUIPMENT. 20V MAX* Cordless Drill/Driver With AutoSense Technology. Some drills come with a small key to tighten the chuck, while keyless chucks are tightened by hand. WARNING: Since accessories, other than those offered by BLACK+DECKER, have not been tested with this product, use of such accessories with this tool could be hazardous. See Privacy Policy or Contact Us at support.blackanddecker@sbdinc.com or 6275 Millcreek Drive, Mississauga, ON L5N 7K6, for more information. A loose bit may eject from tool causing possible personal injury, To insert a drill bit or other accessory, follow these steps..